Andrew buddy Stew-Mac sells this stuff and it will make a fret board, head plate, etc. jet black.
| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Staining an ebony finger board black(er) http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=15203 |
Page 1 of 1 |
| Author: | Andrew Swift [ Tue Jan 01, 2008 6:25 am ] |
| Post subject: | |
i just got a fingerboard from the martin factory and i'm wondering how they get their ebony to such a fine black. Since ebony is not perfectly black i know that some people stain or dye it black with leather dye or something. I'm looking to darken my Madagascar Ebony fingerboard but i don't know what method to use. What works the best for you guys? andrew |
|
| Author: | joelThompson [ Tue Jan 01, 2008 7:10 am ] |
| Post subject: | |
Good ebony should be completly black espesialy if its madagascan. However the lower grade stuff is very often streaked with grey (anything over a B grade should be pretty much fine black with out streaks) to varying degrees. When you work the wood the streaks will disipate slightly. when the fingerboard is in service with a light coat of oil they will be no where near as noticable as when the fingerboard was in its raw state. you can dye the fingerboards and most of the large factorys do just this when using low grade fingerboards. i think stu mac do a good fingerboard dye and have also hear of people using shoe polish but i have only used higher grade ebony on my own guitars so i cant comment on this. i am sure someone else will know the best products to use. i just wated to point out that high grade ebony shouldent need any dyes or staining to make it completly black but be prepard to pay a much as $35 for a high grade madagascan ebony fingerboard. indian eony is a very fine alternative and you can just as good results with less financial outlay (say $20 for a good one). African ebony is third on my list. this stuffi s notorius for streaking. even an a grade african is only as good as most b grade indian ebony fingerboards. as such i try not to supply african unless someone specificaly askes for it good luck, and be sure to let us k ow your results. joel. |
|
| Author: | Hesh [ Tue Jan 01, 2008 8:11 am ] |
| Post subject: | |
Andrew buddy Stew-Mac sells this stuff and it will make a fret board, head plate, etc. jet black. |
|
| Author: | David Collins [ Tue Jan 01, 2008 8:22 am ] |
| Post subject: | |
You can often find Fiebings at leather and shoe repair shops. I get it from a shoe repair shop down the road from me. I have a friend who uses it on his harpsichord flats & sharps too, and it works quite well. |
|
| Author: | FishtownMike [ Tue Jan 01, 2008 12:12 pm ] |
| Post subject: | |
India Ink works well. Black hair dye works to. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|